Turns off on its own
Most Likely Causes
Range/Stove/Power Cord
Most common causeappliancepartsprosIf the connections of the power cord in your electric range's terminal block aren't secure, the wire can get too hot. This can lead to burnt connections on the terminal block and melted wire coating. It's important to make sure these connections are tight and not burnt. If the connectors on the terminal block are burnt, the terminal block needs to be replaced. If the connectors of the power cord are burnt or damaged, you should replace the power cord. If the prongs of the power cord are burnt, a new power cord should be installed. Also, the receptacle should be checked and, if needed, replaced.
Repair Steps
- 1.Disconnect power. Turn off the breaker to cut electricity to the appliance before servicing.
- 2.Open access panel. Remove any screws or clips securing the rear/bottom panel for electrical access.
- 3.Detach strain relief. A rubber grommet grips the old cord where it enters enclosure - remove.
- 4.Disconnect wire leads. Note wire colors/positions and unfasten from range terminal block inside.
- 5.Slide out old cord. Gently withdraw the entirety of the worn power cord from its entry point.